[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B13DA-8FLVDS
(Low voltage differential signaling)
Diagnosis condition
  • When ignition switch is ON
  • When the shift position is reverse or when the camera switch is ON
Signal (terminal)LVDS
ThresholdCommunication error
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
  • LVDS cable connection error (AV control unit to around view monitor control unit)
  • LVDS cable (AV control unit to around view monitor control unit)
 
 
FAIL-SAFE
Intelligent around view monitor display is not displayed.
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 4 minutes or more.
  3. Turn ignition switch ON and wait at least 1 minute or more.
  4. Change the shift position to reverse or press the camera switch to switch to the intelligent around view monitor display.
  5. Select “Self Diagnostic Result” mode of “MULTI AV” using M.U.T.-III SE.
  6. Check DTC.
Is DTC “B13DA-8F” detected?
Proceed to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident
-2Confirmation after repair: INSPECTION END