Diagnosis Procedure
1.
CHECK LVDS CABLE CONNECTION
Turn ignition switch OFF.
Visually check the LVDS cable connector between AV control unit and around view monitor control unit.
Is the inspection result normal?
.
Repair or replace LVDS cable.
2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With M.U.T.-III SE
Turn ignition switch ON.
Erase DTC.
Perform DTC confirmation procedure again. Refer to
DTC Description
.
Is DTC B13DA-8F detected again?
Replace LVDS cable (between AV control unit and around view monitor control unit).
INSPECTION END
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
.
Repair or replace LVDS cable.
With M.U.T.-III SE.Replace LVDS cable (between AV control unit and around view monitor control unit).INSPECTION END