[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B132A-13 External USB
(External USB)
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)USB communication
Threshold—
Diagnosis delay time30 seconds or more
 
 
POSSIBLE CAUSE
  • USB cable is not connected (between AV control unit and front auxiliary input jack)
  • USB cable (between AV control unit and front auxiliary input jack)
  • AV control unit
 
 
FAIL-SAFE
USB is inoperative
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait for 4 minutes.
  3. Turn ignition switch ON and wait at least 1 minute or more.
  4. Select “Self Diagnostic Result” mode of “MULTI AV” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B132A-13 detected?
Proceed to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END