Diagnosis Procedure
1.
ADJUST NEUTRAL POSITION OF STEERING ANGLE SENSOR
Adjusts the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to Description
Description
.
note
When B1383–01 is detected, adjust the predictive course line center position of the steering angle sensor.
:
.
2.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With M.U.T.-III SE
Turn ignition switch ON.
Erase DTC.
Perform DTC confirmation procedure again. Refer to
DTC Description
Is DTC B1383–01 detected again?
Replace steering angle sensor. Refer to
Removal and Installation
.
INSPECTION END
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
..
With M.U.T.-III SE
Replace steering angle sensor. Refer to Removal and Installation.
INSPECTION END