[Previous][Next]
DTC Diagnosis Procedure
1.CHECK CONNECTOR
  1. Turn the ignition switch OFF.
  2. Disconnect the battery cable from the negative terminal.
  3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
    • Wireless charger unit
    • Harness connector M210
    • Harness connector M79
Is the inspection result normal?
.
Repair the terminal and connector.
 
2.CHECK HARNESS FOR OPEN CIRCUIT
  1. Disconnect the connector of wireless charger unit.
  2. Check the resistance between the wireless charger unit harness connector terminals.
    Wireless charger unit harness connectorResistance (Ω)
    Connector No.Terminal No.
    M21326Approx. 54 – 66
Is the measurement value within the specification?
.
Repair the wireless charger unit branch line.
 
3.CHECK POWER SUPPLY AND GROUND CIRCUIT
Check the power supply and the ground circuit of the wireless charger unit. Refer to Diagnosis Procedure.
Is the inspection result normal?
(Present error)Replace the wireless charger unit. Refer to Removal and Installation.
(Past error)Error was detected in the wireless charger unit branch line.
Repair the power supply and the ground circuit.