[Previous][Next]
Removal and Installation
cautionDisconnect the battery negative terminal or remove power circuit fuse when performing the operation for preventing electric leakage. Refer to Precautions for Removing Battery Terminal.
 
 
REMOVAL
 
 
1. Remove power liftgate inner finisher. Refer to Removal and Installation.
2. Remove rear combination light (power liftgate side) mounting nuts .
3. Disconnect rear combination light (power liftgate side) harness connector .
4. Apply protective tapes (A) on the part to protect it from damage.
5. Disengage rear combination light (power liftgate side) fixing clip using a remover tool (A), and then remove rear combination light (power liftgate side).
: Clip
 
 
INSTALLATION
Note the following item, and then install in the reverse order of removal.
cautionVisually check clips for deformation and damage during installation. Replace with new ones if necessary.