Adjustment

	Rear sunroof glass		Glass lid		Roof panel
	: Vehicle front

If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.

note	Standard of surface height is given assuming that the glass upper side status is (+), and the glass lower side status is (−) relative to the roof panel.

Unit: mm [in]

Portion				Standard
Roof panel – Rear sunroof glass	–	E	Clearance	6.3 – 7.9 [0.264 – 0.327]
	–	F	Surface height	(+0.2) – (+1.9) [(−0.039) – (+0.094)]
	–	G	Clearance	6.3 – 7.9 [0.260 – 0.323]
	–	H	Surface height	(+0.2) – (+1.9) [(−0.039) – (+0.094)]
Roof panel – Glass lid	–	I	Clearance	6.3 – 7.9 [0.252 – 0.315]
	–	J	Surface height	(+0.2) – (+1.9) [(−0.039) – (+0.094)]
	–	K	Clearance	6.3 – 7.9 [0.252 – 0.315]
	–	L	Surface height	(+0.2) – (+1.9) [(−0.039) – (+0.094)]

1. Loosen glass lid fixing screws.

2. Adjust the clearance of glass lid and roof panel according to the fitting standard dimension.

3. To prevent glass lid from moving after adjustment, first tighten the fixing screw of front left, and then tighten the screw of rear right.

4. Tighten remaining fixing screws, being careful to prevent glass lid from moving.

5. Tilt glass lid up and down several times to check that it moves smoothly.

note	After adjustment the sunroof unit assembly, perform additional service. Refer to Work Procedure.