[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Fully close rear door glass.
2. Remove rear door finisher. Refer to Removal and Installation.
3. Disconnect rear door outside handle harness connector , and then disengage rear door outside handle harness fixing clip (if equipped).
: Vehicle front
4. Remove door side grommet , and then loosen TORX bolt from grommet hole.
5. Remove rear door outside handle escutcheon from rear door panel.
6. Slide rear door outside handle grip toward rear of vehicle and remove it according to the numerical order 1→2 indicated by arrows as shown in figure.
7. Disengage front gasket and rear gasket fixing pawls, and then remove front gasket and rear gasket.
: Pawl
8. Remove hole seal , and then loosen TROX bolt from hole seal hole.
: Vehicle front
9. Remove rear door outside handle bracket stopper.
: Vehicle front
10. Slide rear door outside handle bracket toward rear of vehicle and remove it.
: Vehicle front
11. Disengage rear door outside handle cable from rear door outside handle cable clip.
12. Disconnect rear door outside handle cable from rear door outside handle bracket according to the numerical order 1→2 indicated by arrows as shown in figure.
 
 
INSTALLATION
Note the following items, and then install in the reverse order of removal.
caution
  • When connecting rear door outside handle cable to rear door outside handle bracket, check that rear door outside handle cable is properly engaged with rear door outside handle bracket.
  • When installing rear door outside handle bracket, be careful that rear door outside handle cable is routed normally.
  • After installation, check rear door lock. Refer to InspectionInspection.