[Previous][Next]
DTC Description
 
 
DESCRIPTION
CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H-line, CAN L-line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen items
(Trouble diagnosis content)
DTC Detection Condition
U215B–87CAN comm err (IPDM E/R)
[CAN communication error (IPDM E/R)]
Diagnosis conditionIgnition switch ON
Signal (terminal)CAN communication signal
ThresholdA/C amp. is not transmitting or receiving CAN communication signal
Diagnosis delay time2 seconds or more
 
 
POSSIBLE CAUSE
CAN communication system
 
 
FAIL-SAFE
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF-DIAGNOSIS
With M.U.T.-III SE
  1. Ignition switch ON.
  2. Perform “Self Diagnostic Result” mode of “HVAC” using M.U.T.-III SE.
  3. Check DTC.
Is DTC detected?
Refer to Diagnosis ProcedureDiagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END