| caution | - For installing/removing the driver knee air bag harness connector, insert a thin screwdriver wrapped in tape into notch, lift lock and remove the connector.
- Install connector with lock raised, and push lock into the connector.
- After installing the connector, check that the lock is pushed securely into it.
- To prevent accidental explosion, always place the driver knee air bag module with deploying direction facing upward.
 | : Upward |
- To prevent damage to the parts, never impact the driver knee air bag module.
- Replace driver knee air bag module if it is dropped or sustains an impact.
- To prevent accidental explosion, never insert any foreign objects (screwdriver, etc.) into the driver knee air bag module.
- To prevent accidental explosion, never disassemble the driver knee air bag module.
- To prevent accidental explosion, never expose the driver knee air bag module to temperature of more than 90 °C (194 °F).
- To prevent damage to the parts, never allow oil, grease, detergent, or water to come in contact with the driver knee air bag module.
|
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
.
, and then remove driver knee air bag module from vehicle body.)
and disengage driver knee air bag module harness fixing clips )
)
)
)