[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Disconnect the battery cable from negative terminal. Refer to Removal and Installation
2. Drain brake fluid. Refer to DrainingDraining.
3. Remove the engine cover. Refer to Removal and Installation.
4. Remove the cowl top extension. Refer to Removal and Installation.
5. Remove heat insulator .
: Vehicle front
6. Disconnect ABS actuator and electric unit (control unit) harness connector , follow the procedure below.
(1) Down the pawl .
(2) Push the connector .
(3) Move the lever in the direction until locked.
(4) Disconnect ABS actuator and electric unit (control unit) harness connector.
7. Loosen flare nut of brake tube using a flare nut wrench.
8. Remove front brake piping from the clip.
9. Remove the bolt at the ABS actuator and electric unit (control unit) bracket upper side, then remove the ABS actuator and electric unit as a set with bracket.
caution
  • Never remove and never install ABS actuator and electric unit (control unit) by holding harness connector.
  • Be careful not to drop ABS actuator and electric unit (control unit) and apply excessive impact to it.
10. Remove bracket from ABS actuator and electric unit (control unit).
 
 
INSTALLATION
Note the following, and install in the reverse order of removal.
  • When replacing ABS actuator and electric unit (control unit), remove the inlet hole protector for brake tube just before performing.
  • When installing brake tube, tighten to the specified torque using a flare nut torque wrench so that flare nut and brake tube are not damaged. Refer to Exploded View
  • Never remove and install actuator by holding actuator harness.
  • Bleed air from brake piping after installation. Refer to Bleeding Brake System.
  • Never apply excessive impact to actuator, such as by dropping it.
  • After installing the ABS actuator and electric unit (control unit) harness connector , move the lever in the direction and up the pawl to secure the locking.
  • When replacing the ABS actuator and electric unit (control unit), be sure to perform the configuration. Refer to Work Procedure.