[Previous][Next]
Diagnosis Procedure
1.CHECK CONNECTOR
  1. Disconnect 12V battery negative terminal.
  2. Check the brake vacuum sensor harness connector for disconnection or looseness.
  3. Check the ABS actuator and electric unit (control unit) harness connector for disconnection or looseness.
Is the inspection result normal?
GO tO 2.
Repair / replace harness or connector. .
 
2.CHECK BRAKE BOOSTER
Check the brake booster. Refer to InspectionInspection.
Is the inspection result normal?
GO TO 3
Replace the brake booster. Refer to Removal and InstallationRemoval and installation.
 
3.CHECK VACUUM PIPING
Check the vacuum piping. Refer to Inspection.
Is the inspection result normal?
GO TO4
Replace the vacuum piping. Refer to Removal and Installation.
 
4.CHECK TERMINAL
  1. Disconnect 12V battery negative terminal.
  2. Disconnect brake vacuum sensor harness connector.
  3. Check the brake vacuum sensor terminals for damage or loose connection with harness connector.
  4. Disconnect ABS actuator and electric unit (control unit) harness connector.
  5. Check the ABS actuator and electric unit (control unit) terminals for damage or loose connection with harness connector.
Is the inspection result normal?
GO TO 5.
Repair / replace harness, connector, or terminal.
 
5.CHECK BRAKE VACUUM SENSOR CIRCUIT
  1. Disconnect brake vacuum sensor harness connector.
  2. Disconnect ABS actuator and electric unit (control unit) harness connector.
  3. Check the continuity between brake vacuum sensor harness connector and ABS actuator and electric unit (control unit) harness connector.
    Brake vacuum sensorABS actuator and electric unit (control unit)Continuity
    ConnectorTerminalConnectorTerminal
    E1671E12545Existed
    228
    317
  4. Check the continuity between brake vacuum sensor harness connector and ground.
    Brake vacuum sensor—Continuity
    ConnectorTerminal
    E1671GroundNot existed
    2
    3
Is the inspection result normal?
.
Repair / replace harness or connector.
 
6.REPLACE BRAKE VACUUM SENSOR
With M.U.T.-III SE
  1. Connect ABS actuator and electric unit (control unit) harness connector.
  2. Replace the brake vacuum sensor.
    cautionAlways replace brake booster because brake vacuum sensor cannot be disassembled. Refer to Removal and InstallationRemoval and installation.
  3. Connect 12V battery negative terminal.
  4. Erase self-diagnosis result for “ABS”.
  5. Ignition switch OFF (Auto ACC function OFF) → ON → OFF (Auto ACC function OFF).
  6. Start engine.
    noteWait at least 10 seconds after start the engine.
  7. Perform self-diagnosis for “ABS”.
Is DTC “C106D-01” detected?
Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.
INSPECTION END