Diagnosis Procedure

1.CHECK TIRE PRESSURE SIGNAL

With M.U.T.-III SE

Select "BCM", "Data List", and "AIR PRESS-RR" in this order.
Check that the rear right tire pressures match the standard value. Refer to Reference Value.
note BCM holds last tire pressure values during 17 minutes after ignition switch turns OFF.

Are all tire pressures displayed 0 kPa (psi)?

2.CHECK BCM POWER SUPPLY CIRCUIT

Check BCM power supply circuit. Refer to Diagnosis Procedure

Is the inspection result normal?

Repair or replace harness or connectors.

3.TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to Description

Can the tire pressure sensor ID registration be completed?

Replace applicable rear right tire pressure sensor. Refer to Removal & Installation

4.RECHECK TIRE PRESSURE SIGNAL

With M.U.T.-III SE

Drive the vehicle at 40 km/h (25MPH) or more reaches 10 minuets in total.
note Avoid driving in areas with radio interference.
Stop the vehicle.
Select "BCM", "Data List", and "AIR PRESS-RR" in this order.
Check that the rear right tire pressures match the standard value. Refer to Reference Value.

Is the inspection result normal?

After erasing DTC record, INSPECTION END