[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Drain the transfer oil. Refer to Draining.
2. Remove front drive shaft (right side). Refer to Removal and Installation.
cautionOil may leak from the opening. Use cap and/or plug to prevent leakage.
3. Remove transfer cover oil seal (outer/inner), using oil seal remover (commercial service tool).
cautionNever damage transfer cover.
 
 
INSTALLATION
 
 
1. Using drift (commercial service tool), install transfer cover oil seal (outer/inner) with the directions below.
A: Installation dimension for transfer cover oil seal (inner)
B: Installation dimension for transfer cover oil seal (outer)
Dimension
A: 10.3 +0.6/-0 mm (0.406 +0.024/-0 in)
B: 0 +0.6/-0 mm (0 +0.024/-0 in)
noteThe positive value is deeper than the transfer cover end face.
caution
  • Never reuse oil seal.
  • When installing, never incline oil seal.
  • Apply multi-purpose grease onto oil seal lips, and transfer oil onto the circumference of oil seal.
  • When installing the outer oil seal , the notch is located on the lower side.
2. Install front drive shaft (right side). Refer to Removal and Installation.
3. Refill the transfer oil to transfer assembly. Refer to Refilling.
4. Check the oil level and the oil leakage after installation. Refer to Inspection.