[Previous][Next]
DTC Diagnosis Procedure
1.CHECK ENCODER POWER SUPPLY CIRCUIT
  1. The ignition switch is OFF.
  2. Disconnect the shift actuator connector.
  3. The ignition switch is ON.
  4. Check the voltage between shift actuator harness connector terminal and ground.
    +−Voltage
    (Approx.)
    Shift actuator
    ConnectorTerminal
    F9710Ground5 V
Is the inspection result normal?
.
.
 
2.CHECK ENCODER GROUND CIRCUIT
  1. The ignition switch is OFF.
  2. Check the continuity between shift actuator harness connector terminal and ground.
    Shift actuator—Continuity
    ConnectorTerminal
    F9711GroundExisted
  3. Disconnect the electric shift control module connector.
  4. Check the continuity between electric shift control module harness connector terminal and ground.
    Electric shift control module—Continuity
    ConnectorTerminal
    E13023GroundNot existed
Is the inspection result normal?
.
Repair or replace damaged parts.
 
3.CHECK ENCODER SIGNAL CIRCUIT
  1. Check the continuity between electric shift control module harness connector terminals and shift actuator harness connector terminals.
    Electric shift control moduleShift actuatorContinuity
    ConnectorTerminalConnectorTerminal
    E13015F9712Existed
    2414
  2. Check the continuity between electric shift control module harness connector terminals and ground.
    Electric shift control module—Continuity
    ConnectorTerminal
    E13015GroundNot existed
    24
Is the inspection result normal?
Replace the transaxle assembly due to malfunction in the encoder (shift actuator). Refer to Remove and InstallationRemoval and Installation.
Repair or replace damaged parts.
 
4.CHECK ENCODER POWER SUPPLY CIRCUIT
  1. The ignition switch is OFF.
  2. Disconnect the electric shift control module connector.
  3. Check the continuity between electric shift control module harness connector terminals and shift actuator harness connector terminals.
    Electric shift control moduleShift actuatorContinuity
    ConnectorTerminalConnectorTerminal
    E13016F9710Existed
  4. Check the continuity between electric shift control module harness connector terminals and ground.
    Electric shift control module—Continuity
    ConnectorTerminal
    E13016GroundNot existed
Is the inspection result normal?
Replace the electric shift control module. Refer to Removal and Installation.
Repair or replace damaged parts.