[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P07EF00T/M RANGE SELECTOR
(Transmission Range Multi-Function Select Circuit Low)
Diagnosis conditionWhen the ignition switch is ON
SignalElectric shift sensor signal
ThresholdAll electric shift sensors No. 1 to No. 8 are OFF.
Diagnosis delay time—
Shift position judgement table
Selector lever positionElectric shift sensor
No. 1No. 2No. 3No. 4No. 5No. 6No. 7No. 8
RONONOFFOFFOFFOFFOFFOFF
NrONONONONONOFFOFFOFF
HONONONONONONONON
NdOFFOFFOFFONONONONON
D/MOFFOFFOFFOFFOFFOFFONON
 
 
POSSIBLE CAUSE
  • Electric shift control module
  • Electric shift sensor
  • Harness or connectors (Electric shift sensor circuit is open or shorted.)
 
 
FAIL-SAFE
Powertrain becomes neutral
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. The ignition switch is ON and wait for 10 seconds or more.
  2. Check DTC.
Is “P07EF-00 detected?
Go to DTC Diagnosis Procedure.
-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END