[Previous][Next]
DTC Diagnosis Procedure
1.CHECK ELECTRIC SHIFT SELECTOR POWER SUPPLY CIRCUIT
  1. The ignition switch is OFF.
  2. Disconnect the electric shift selector connector.
  3. The ignition switch is ON.
  4. Check the voltage between electric shift selector harness connector terminal and ground.
    Electric shift sensor+-Voltage
    (Approx.)
    Electric shift selector
    ConnectorTerminal
    1, 3, 5, 7M21Ground5 V
    2, 4, 6, 813
Is the inspection result normal?
.
.
 
2.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND ELECTRIC SHIFT SELECTOR
  1. The ignition switch is OFF.
  2. Disconnect the electric shift control module connector.
  3. Check the continuity between the electric shift control module harness connector terminal and the electric shift selector harness connector terminal.
    Electric shift sensorElectric shift control moduleElectric shift selectorContinuity
    ConnectorTerminalConnectorTerminal
    1, 3, 5, 7E13019M21Existed
    2, 4, 6, 8E1314813
  4. Check the continuity between the electric shift control module harness connector terminal and ground.
    Electric shift sensorElectric shift control module−Continuity
    ConnectorTerminal
    1, 3, 5, 7E13019GroundNot existed
    2, 4, 6, 8E13148
Is the inspection result normal?
Replace the electric shift control module. Refer to Removal and Installation.
Repair or replace damaged parts.
 
3.CHECK ELECTRIC SHIFT SELECTOR GROUND CIRCUIT
  1. The ignition switch is OFF.
  2. Disconnect the electric shift control module connector.
  3. Check the continuity between the electric shift control module harness connector terminal and the electric shift selector harness connector terminal.
    Electric shift sensorElectric shift control moduleElectric shift selectorContinuity
    ConnectorTerminalConnectorTerminal
    1, 3, 5, 7E13141M212Existed
    2, 4, 6, 85024
  4. Check the continuity between the electric shift control module harness connector terminal and ground.
    Electric shift sensorElectric shift control module−Continuity
    ConnectorTerminal
    1, 3, 5, 7E13141GroundNot existed
    2, 4, 6, 850
Is the inspection result normal?
.
Repair or replace damaged parts.
 
4.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND ELECTRIC SHIFT SELECTOR
  1. Check the continuity between the electric shift control module harness connector terminal and the electric shift selector harness connector terminal.
    Electric shift sensorElectric shift control moduleElectric shift selectorContinuity
    ConnectorTerminalConnectorTerminal
    1E13134M22Existed
    23514
    3363
    43715
    5444
    64516
    7395
    84017
  2. Check the continuity between the electric shift control module harness connector terminals and ground.
    Electric shift sensorElectric shift control module−Continuity
    ConnectorTerminal
    1E13134GroundNot existed
    235
    336
    437
    544
    645
    739
    840
Is the inspection result normal?
Replace the electric shift selector. Refer to Removal and Installation.
Repair or replace damaged parts.