DTC Description

DTC DETECTION LOGIC

DTC		M.U.T.-III SE screen terms (Trouble diagnosis content)	DTC detection condition
P07EE^*	00	T/M RANGE SELECTOR (Transmission Range Multi-Function Select Circuit Range/Performance)	Diagnosis condition	When the ignition switch is ON
			Signal	Electric shift sensor signal
			Threshold	The electric shift sensor signal which the electric control module receives is abnormal.
			Diagnosis delay time	—

*: This code is displayed as P0914 on GST.

POSSIBLE CAUSE

Electric shift control module

FAIL-SAFE

Shifting operation is prohibited
Powertrain becomes neutral

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.

2.PERFORM DTC CONFIRMATION PROCEDURE

The ignition switch is ON.
Shift the selector lever as follows. (Hold the selector lever at each position for 2 seconds or more.)
H → Nr → R → Nd → D/M → H
Check DTC.

Is “P07EE-00 detected?

Go to Diagnosis ProcedureDTC Diagnosis Procedure

-1To check malfunction symptom before repair: Go to Intermittent IncidentIntermittent Incident

-2Confirmation after repair: INSPECTION END