[Previous][Next]
Diagnosis Procedure
1.CHECK ELECTRIC SHIFT SELECTOR INPUT VOLTAGE
Check the voltage between electric shift selector harness connector terminal and ground.
+−ConditionVoltage
(Approx.)
Electric shift control module
ConnectorTerminal
M21GroundIgnition switch is ON5 V
13
Is the inspection results normal?
.
.
 
2.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND ELECTRIC SHIFT SELECTOR - 1
  1. The ignition switch is OFF.
  2. Disconnect the electric shift selector connector.
  3. Disconnect the electric shift control module connector.
  4. The ignition switch is ON.
  5. Check the voltage between the electric shift control module harness connector terminal and ground.
    +−Voltage
    (Approx.)
    Electric shift control module
    ConnectorTerminal
    E13119Ground0 V
    48
  6. The ignition switch is OFF.
  7. Check the continuity between the electric shift control module harness connector terminals.
    Electric shift control moduleElectric shift control moduleContinuity
    ConnectorTerminalConnectorTerminal
    E13019E130Except 19Not existed
    E13148E131Except 48
Is the inspection results normal?
Replace the electric shift control module. Refer to Removal and Installation.
Repair or replace damaged parts.
 
3.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND ELECTRIC SHIFT SELECTOR - 2
  1. The ignition switch is OFF.
  2. Disconnect the electric shift selector connector.
  3. Disconnect the electric shift control module connector.
  4. The ignition switch is ON.
  5. Check the voltage between the electric shift control module harness connector terminal and ground.
    P position switch+―Voltage
    (Approx.)
    Electric shift control module
    ConnectorTerminal
    Switch 1E13146Ground0 V
    Switch 247
  6. The ignition switch is OFF.
  7. Check the continuity between the electric shift control module harness connector terminals.
    P position switchElectric shift control moduleElectric shift control moduleContinuity
    ConnectorTerminalConnectorTerminal
    Switch 1E13146E131Except 46Not existed
    Switch 247Except 47
Is the inspection results normal?
.
Repair or replace damaged parts.
 
4.REPLACE ELECTRIC SHIFT SELECTOR
  1. Replace the electric shift selector. Refer to Removal and Installation.
  2. Connect all of disconnected connectors.
  3. Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
Replace the electric shift control module. Refer to Removal and Installation.
INSPECTION END