[Previous][Next]
Component Inspection
1.CHECK TRANSMISSION RANGE SWITCH
  1. Remove the electric shift actuator. Refer to Removal and Installation.
    .
  2. Set the transmission range switch adjustment tool (A) to manual shaft.
    : Transmission range switch
  3. Check continuity between transmission range switch connector terminals.
    Transmission range switchConditionContinuity
    Terminal
    4 – 5Manual lever: “P” positionExisted
    Other than the aboveNot existed
    4 – 8Manual lever: “R” positionExisted
    Other than the aboveNot existed
    4 – 9Manual lever: “N positionExisted
    Other than the aboveNot existed
    4 – 2Manual lever: “D” positionExisted
    Other than the aboveNot existed
Is the inspection result normal?
INSPECTION END
There is a malfunction of transmission range switch. Replace transmission range switch. Refer to Removal and Installation.