[Previous][Next]
DTC U0331: ECU internal error
 
 
 
 
TROUBLE JUDGMENT
If the ETACS-ECU error counter value is detected to be "255," DTC U0331 is set, and the ETACS-ECU is reset. The DTC U0331 exists only as past trouble.
 
 
TROUBLESHOOTING HINTS
  • The ETACS-ECU may be defective.
 
 
DIAGNOSIS
Recheck for diagnostic trouble code.
Check again if the DTC is set to the ETACS-ECU.
(1)
cautionTo prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
Connect scan tool MB991958. Refer to "How to connect the Scan Tool (M.U.T.-III) ."
(2) Turn the ignition switch to the "ON" position.
(3) Erase the DTC.
(4) Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(5) Check if DTC is set.
(6) Turn the ignition switch to the "LOCK" (OFF) position.
Is the DTC set?
Replace the ETACS-ECU.
The diagnosis is complete.