[Previous][Next]
Inspection Procedure 1: The hazard warning lights do not illuminate.
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
 
 
TECHNICAL DESCRIPTION (COMMENT)
If the hazard warning light does not illuminate, the hazard warning light switch input circuit in hazard indicator assembly or the ETACS-ECU may have a problem.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of hazard indicator assembly
  • Malfunction of the ETACS-ECU
  • The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
 
 
DIAGNOSIS
STEP 1. Check that the turn-signal light operate.
Check that the turn-signal lights illuminate normally.
Does turn-signal light work normally?
Go to Step 2.
Diagnose the headlights. Refer to Inspection Procedure 11 "None of turn-signal lights illuminates" .
 
STEP 2. Using scan tool MB991958, check data list.
Using the ETACS-ECU service data, check the hazard warning light signal.
cautionTo prevent damage to scan tool MB991958, always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool MB991958.
1. Connect scan tool MB991958. Refer to "How to connect scan tool (M.U.T.-III) ."
2. Turn the ignition switch to the "ACC" position.
3. Turn "ON" the hazard light switch.
 
Item No.Item nameNormal conditions
Item 265Hazard switchON
Does scan tool MB991958 display the items "Hazard switch" as normal condition?
(Normal condition is displayed for item) Go to Step 3.
(Normal condition is not displayed for item No. 265.) Troubleshoot the ETACS-ECU. Refer to ETACS, Diagnosis - Inspection Procedure 10 "ETACS-ECU does not receive any signal from the hazard warning light switch" .
 
STEP 3. Retest the system
Check that the hazard warning light illuminate normally.
Does the taillight work normally?
The trouble can be an intermittent malfunction (Refer to GROUP 00, How to use Troubleshooting/inspection Service Points, How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU.