[Previous][Next]
SPECIAL TOOLS
 
 
ToolTool number and nameSupersessionApplication
MB990784
Ornament remover
General service toolRemoval of cover.
MB990803
Steering wheel puller
General service toolSteering wheel removal
MB991958
  • a: MB991824
  • b: MB991827
  • c: MB991910
  • d: MB991911
  • e: MB991914
  • f: MB991825
  • g: MB991826
Scan tool (M.U.T.-III sub assembly)
  • a: Vehicle communication interface (V. C. I.)
  • b: M.U.T.-III USB cable
  • c: M.U.T.-III main harness A (Vehicles with CAN communication system)
  • d: M.U.T.-III main harness B (Vehicles without CAN communication system)
  • e: M.U.T.-III main harness C (for Chrysler models only)
  • f: M.U.T.-III measurement adapter
  • g: M.U.T.-III trigger harness
MB991824-KIT
noteg: MB991826 M.U.T.-III Trigger Harness is not necessary when pushing V.C.I. ENTER key.
cautionFor vehicles with CAN communication, use M.U.T.-III main harness A to send simulated vehicle speed. If you connect M.U.T.-III main harness B instead, the CAN communication does not function correctly.
Checking diagnostic trouble code
MB991865
Dummy resistor
-SRS air bag and seat belt pre-tensioner circuit check
MB991866
Resistor harness
-Driver’s and passenger’s (front) air bag and side-air bag circuit check
MB991884
Resistor harness
-Curtain air bag and seat belt pre-tensioner circuit check
MB991885
Adapter harness
-Deployment of Knee air bag, curtain air bag and seat belt pre-tensioner inside or outside the vehicle
MB991223
  • a: MB991219
  • b: MB991220
  • c: MB991221
  • d: MB991222
Harness set
  • a: Test harness
  • b: LED harness
  • c: LED harness adaptor
  • d: Probe
General service toolsChecking the continuity and measuring the voltage at the SRS-ECU harness connector
MB992102
Air bag inflation adapter harness
-Deployment of driver’s and passenger’s (front) air bag module inside or outside the vehicle
MB992006
Extra fine probe
General service toolContinuity check and voltage measurement at harness wire or connector for loose, corroded or damaged terminals, or terminals pushed back in the connector.