[Previous][Next]
REMOVAL AND INSTALLATION
 
 
cautionDo not apply grease or lubricant to the switch and the switch installation section to avoid malfunction of the switch. In addition, do not use gloves which have grease on them.
Pre-removal operation
  • Rear Console Removal (Refer to GROUP 52A - Rear Floor Console Assembly ).
  • Floor Console Rear Base Removal (Refer to GROUP 52A - Front Floor Console Assembly ).
Post-installation operation
  • Parking Brake Lever Stroke Check (Refer to ).
  • Floor Console Rear Base Installation (Refer to GROUP 52A - Front Floor Console Assembly ).
  • Rear Console Installation (Refer to GROUP 52A - Rear Floor Console Assembly ).
Removal steps
•Release the parking brake lever.
1.Parking brake switch connector connection
2.Adjusting nut
>>A<<3.Parking brake rear cable assembly connection
4.Parking brake lever assembly
5.Parking brake switch
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< PARKING BRAKE REAR CABLE ASSEMBLY CONNECTION INSTALLATION
cautionCheck that the equalizer and the parking brake rear cable assembly are connected correctly. If the parking brake is applied with the equalizer and the parking brake rear cable assembly connected improperly, the equalizer may be damaged.
Connect the parking brake rear cable assembly to the equalizer as shown in the figure.