[Previous][Next]
DISASSEMBLY AND REASSEMBLY
 
 
Disassembly steps
1.Flange bolt
2.Caliper support
3.Brake pad assembly
4.Brake pad and wear indicator assembly
5.Shim
6.Clip
7.Guide pin
8.Bushing
9.Lock pin
10.Pin boot
<<A>>>>A<<11.Piston
12.Piston boot
13.Piston seal
14.Spring
15.Bleeder cap
16.Bleed screw
17.Caliper body
 
 
LUBRICATION POINTS
Required Special Tools:
 
 
DISASSEMBLY SERVICE POINTS
 
 
<<A>> PISTON REMOVAL
Use the special tool, rear disc brake piston driver (MB991621) to turn the piston as shown, and remove it from the caliper body.
 
 
 
 
REASSEMBLY SERVICE POINTS
 
 
>>A<< PISTON INSTALLATION
1. Use the special tool, rear disc brake piston driver (MB991621) as shown to turn the piston and install to the caliper body.
2. Set as shown so that the protrusion on the pad assembly rear face is engaged in the piston stopper groove.