When the engine mounting insulator, transaxle mounting insulator and rear roll stopper have been removed, tighten the engine mounting insulator, transaxle mounting insulator and rear roll stopper securely. Then, tighten the front roll stopper center nut *1 securely.
The parts indicated by the *2 are the bolts with friction coefficient stabilizer. Prior to reinstallation, ensure there is no damage, clean dust and soiling from bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal and post-installation operation
Engine Room Under Cover Front B Removal and Installation (Refer to GROUP 51 - Under Cover ).
Front roll stopper and centermember removal steps
1.
Centermember hook
2.
Centermember assembly
>>A<<
3.
Front roll stopper
Rear roll stopper removal <FWD>
5.
Rear roll stopper
Rear roll stopper removal steps <AWD>
1.
Centermember hook
4.
Centermember
5.
Rear roll stopper
INSTALLATION SERVICE POINT
>>A<< FRONT ROLL STOPPER INSTALLATION
Install the front roll stopper so that the hole faces toward the vehicle front.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
