When removing the fuel pipes and fuel hoses, follow the procedure below to release fuel pressure in the line and prevent fuel from running out, because fuel pressure in the fuel line is high.1. Remove the rear seat cushion assembly (Refer to GROUP 52A - Rear Seat Assembly 
). 2. Remove the floor inspection lid (LH).
3. Disconnect the fuel pump module connector.
4. Crank the engine for at least two seconds.
5. If the engine does not start, turn the ignition switch to the "LOCK" (OFF) position.
6. If the engine is started, turn the ignition switch to the "LOCK" (OFF) position after the engine stopped.
7. Connect the fuel pump module connector.
8. Install the floor inspection lid (LH).
9. Install the rear seat cushion assembly (Refer to GROUP 52A - Rear Seat Assembly ). ![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)