[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal and post-installation operation
  • Rear wheelhouse splash shield (Refer to GROUP 42A, Splash Shield )
  • Rear combination light removal and installation (Refer to GROUP 54A-Rear combination light )
  • Rear bumper harness connector connection removal and installation
Removal steps
1.Liftgate damper
2.Rear bumper assembly
3.Rear fog light cover
4.Reflector
5.Rear bumper cover
6.Rear bumper face
7.Rear bumper face support bracket
8.Rear bumper reinforcement
>>A<<9.Rear bumper reinforcement nut
 
 
REASSEMBLY SERVICE POINT
 
 
>>A<< REAR BUMPER REINFORCEMENT NUT INSTALLATION
It is recommended that the tool shown in the figure should be used to install the rear bumper reinforcement nut.