[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
  • Engine Room Under Cover Front A Removal (Refer to .)
  • Splash Shield Mounting Clips Removal (Refer to GROUP 42A, Splash Shield .)
  • Front Wiring Harness Connector and Fog Light Wiring Harness Connector Connection <Vehicles with Fog Light>
Post-installation Operation
  • Front Wring Harness Connector and Fog Light Wring Harness Connector Connection <Vehicles with Fog Light>
  • Splash Shield Mounting Clips Installation (Refer to GROUP 42A, Splash Shield .)
  • Engine Room Under Cover Front A Installation. (Refer to .)
  • Front Fog Light Aiming Adjustment (Refer to GROUP 54A, Fog Light - On-vehicle Service ).
Removal steps
1.Hood weatherstrip front
2.Headlight support upper panel cover
<<A>>•Front wheel arch molding front part
>>A<<3.Front bumper assembly
4.Front bumper nut
5.Front bumper cover
6.Front bumper core
7.Headlight support upper panel
•Horn (Refer to GROUP 54A, Horn )
•Front harness
•Ambient temperature sensor (Refer to GROUP 55A, Ambient Temperature Sensor )
8.Front bumper reinforcement A
 
 
REMOVAL SERVICE POINT
 
 
<<A>> FRONT WHEEL ARCH MOLDING FRONT PART REMOVAL
cautionTo prevent the front wheel arch molding from damage, pull it gradually and do not over-pull it.
Before removing the front bumper assembly, release the front part of the front wheel arch molding by pulling and unclipping it outwards. This makes the bumper removal possible without removing the entire front wheel arch molding.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< FRONT BUMPER ASSEMBLY INSTALLATION
Install the bolts in the order shown.