[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal and Post-installation operation
  • Engine Room Under Cover Front A, B and Engine Room Side Cover (LH) Removal and Installation (Refer to GROUP 51 -Under Cover ).
  • Battery and Battery Tray Removal and Installation (Refer to GROUP 54A - Battery ).
  • Relay Box Mounting Bolts Removal and Installation.
  • Air Cleaner Assembly Removal and Installation (Refer to GROUP 15 - Air Cleaner ).
  • Engine Control Module (ECM) and Bracket Removal and Installation (Refer to GROUP 13A - Engine Control Module (ECM) <2.0L Engine> or GROUP 13C - Engine Control Module (ECM) <2.4L Engine>).
<M/T>
<CVT>
Removal steps
<<A>>1.Transaxle mounting bracket
>>A<<2.Transaxle mounting insulator stopper
3.Transaxle mounting insulator
 
 
REMOVAL SERVICE POINT
 
 
<<A>> TRANSAXLE MOUNTING BRACKET REMOVAL
1. Place a garage jack against the transaxle case with a piece of wood in between to support the engine and transaxle assembly.
2. Operate a garage jack so that the transaxle weight is not applied to the transaxle mounting insulator, and remove the transaxle mounting insulator.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< TRANSAXLE MOUNTING INSULATOR STOPPER INSTALLATION
Install the transaxle mounting insulator stopper as shown in the figure.