[Previous][Next]
DATA LIST REFERENCE TABLE
Scan tool can read the following items among various control data (input data from each ECU and switch) used by the electronic control AWD system.
 
 
SYSTEM IS NORMAL.
Item No.Check itemCheck conditionNormal condition
01Vehicle speed (AWD calculated value)Perform a test run of the vehicle.The speedometer display and the scan tool display almost agree with each other.
02Ignition power supply voltageIgnition switch: ON9 - 16 V
03Coupling torque
  • Drive mode selector: 4WD (AWD)
  • Perform a test run of the vehicle.
0 - 730 N·m (0 - 538 ft-lb)
04Coupling current (command value)
  • Drive mode selector: 4WD (AWD)
  • Perform a test run of the vehicle.
The current changes between 0 and 3 A. (Command value and actual value agree with each other.)
05Coupling current (monitor value)
  • Drive mode selector: 4WD (AWD)
  • Perform a test run of the vehicle.
The current changes between 0 and 3 A. (Command value and actual value agree with each other.)
06Coupling temperature
  • Drive mode selector: 4WD (AWD)
  • Perform a test run of the vehicle.
0 - 200°C (0 - 392°F)
noteDue to road surface condition the load to coupling varies, thus the temperature indication changes.
07CAN system (ASC)Ignition switch: ONWhen ASC-ECU data is correctly receivedOK
When ASC-ECU data reception error occursNo reception
08CAN system (engine)Ignition switch: ONWhen engine control module data is correctly receivedOK
When engine control module data reception error occursNo reception
09CAN system (ETACS)Ignition switch: ONWhen ETACS-ECU data is correctly receivedOK
When ETACS-ECU data reception error occursNo reception
10FWD SWIgnition switch: ONDrive mode selector: 2WD (FWD)ON
Drive mode selector: 4WD (AWD)OFF
Drive mode selector: LOCKOFF
11LOCK/PUSH SWIgnition switch: ONLOCK SW : OFFOFF
LOCK SW : ONON
15AWD modeIgnition switch: ON2WD (FWD)2WD (FWD)
4WD (AWD)4WD (AWD)
LOCKAWD LOCK
16FL wheel speed sensorPerform a test run of the vehicle.
Check that there is difference between the right wheel speed and the left wheel speed when the vehicle turns.
The speedometer display and the scan tool display almost agree with each other.
17FR wheel speed sensor
18RL wheel speed sensor
19RR wheel speed sensor
21Engine speedPerform a test run of the vehicle.The tachometer display and the scan tool display almost agree with each other.
23Ignition positionONON
STARTSTART
26Throttle positionIgnition switch: ONRelease the accelerator pedal.Approximately 0%
Gradually depress the accelerator pedal.0 - 100%
Fully depress the accelerator pedal.Approximately 100% (within 100%)
28Limited torquePerform a test run of the vehicle.Usually-
When ASC works and AWD-ECU limits the torque in cooperation control with ASC
noteElectronic control AWD will limit occasionally the rear wheel transmission torque in cooperation control with ASC. When this limit is applied, the limited torque will be shown.
0 - 730 N·m (0 - 538 ft-lb)
 
 
SYSTEM SHUT-DOWN
Scan tool display data does not agree with the actual data when AWD-ECU deactivates the AWD control function by the fail-safe function.