DIAGNOSTIC FUNCTION
TCM detects the abnormal wave pattern of the speed sensor signal.
DESCRIPTIONS OF MONITOR METHODS
- Rotational fluctuation of primary pulley is large (for 1 second).
- Rotational fluctuation of secondary pulley is large (for 1 second).
MONITOR EXECUTION CONDITIONS (OTHER MONITOR AND SENSOR)
Other Monitor (There is no temporary DTC stored in memory for the item monitored below)
- P0740: Malfunction of lockup solenoid valve
- P0745: Malfunction of line pressure solenoid valve
- P0840: Malfunction of secondary pressure sensor
Sensor (The sensor below is determined to be normal)
- Secondary pressure sensor
LOGIC FLOW CHARTS (Monitor Sequence)
DTC SET CONDITIONS
Check Conditions
- Voltage of battery: 9 volts or more.
- Voltage of battery: 16 volts or less.
Judgment Criteria
- Noise of primary pulley or primary pulley speed sensor signal: more than 30 r/min. (1 second)
- Noise of primary pulley or secondary pulley speed sensor signal: more than 30 r/min. (1 second)
OBD-II DRIVE CYCLE PATTERN
Ignition switch: ON (start the engine and keep it for 10 seconds or more)
PROBABLE CAUSES
- Malfunction of primary pulley speed sensor
- Malfunction of secondary pulley speed sensor
- Malfunction of TCM