Bottom cover assembly (passenger's side) (Refer to GROUP 52A - Instrument Panel ).
1.
Blower motor
Air mixing damper control motor, mode selection damper control motor removal steps
•
Foot duct (Refer to ).
<<A>>
2.
Air mixing damper control motor (driver’s side)
<<A>>
3.
Air mixing damper control motor (passenger's side)
<<A>>
4.
Mode selection damper control motor
Clean air filter removal steps
•
Glove box, Globe box assembly (Refer to GROUP 52A - Instrument Panel ).
5.
Clean air filter cover
>>B<<
6.
Clean air filter
Outside/inside air selection damper control motor removal steps
•
Glove box, Globe box assembly (Refer to GROUP 52A - Instrument Panel ).
<<A>>
>>A<<
7.
Outside/inside air selection damper control motor
REMOVAL SERVICE POINT
<<A>> AIR MIXING DAMPER CONTROL MOTOR, OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR, MODE SELECTION DAMPER CONTROL MOTOR REMOVAL
note
A normal plate-type ratchet driver is recommended.
INSTALLATION SERVICE POINT
>>A<< OUTSIDE/INSIDE AIR SELECTION DAMPER CONTROL MOTOR INSTALLATION
Install the outside/inside air selection damper control motor while pressing the outside/inside air selection damper from the hole of the blower motor.
>>B<< CLEAN AIR FILTER INSTALLATION
Install the clean air filter in the direction shown.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
)
)
)
