[Previous][Next]
DTC P1E0F: Battery pack state of charge stuck
cautionWhenever ECU is replaced, ensure that the CAN bus lines are normal.
 
 
 
 
MONITOR EXECUTION
  • Continuous
 
 
MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)
Other Monitor (There is no temporary DTC set in memory for the item monitored below)
  • Not applicable
Sensor (The sensor below is determined to be normal)
  • Not applicable
 
 
DTC SET CONDITIONS
Logic Flow Chart
Check Conditions
  • battery management unit (BMU) power supply voltage is 8 volts to 16 volts.
  • Time after above conditions satisfy is more than 2 second.
Judgment Criterion
  • SOC fault counter is more than 3 time.
 
 
FAIL-SAFE AND BACKUP FUNCTION
  • Not available
 
 
PROBABLE CAUSES
  • The battery management unit (BMU) is failed.
 
 
 
 
DIAGNOSIS
Replace the battery management unit (BMU) (Refer to ).