STEP 2. Resistance measurement at joint connector (CAN3) and column switch connector.
caution | A digital multimeter should be used. For details refer to . |
caution | The test wiring harness should be used. For details refer to . |
(1) Disconnect joint connector (CAN3) and the column switch connector, and measure at the wiring harness side.
(2) Turn off the power supply mode of the electric motor switch.
(3) caution | When measuring the resistance, disconnect the negative 12V starter battery terminal. For details refer to . |
Ensure that the negative 12V starter battery terminal is disconnected.
(4) Continuity between joint connector (CAN3) terminal No.6 and column switch connector terminal No.3OK: Continuity (2 ohms or less)
(5) Continuity between joint connector (CAN3) terminal No.17 and column switch connector terminal No.4OK: Continuity (2 ohms or less)
caution | Strictly observe the specified wiring harness repair procedure. For details refer to . |
Is the check result normal?
<All the resistance measure 2 ohms or less> Go to Step 3. : <Either or all of the resistances measure more than 2 ohms> Repair the wiring harness between joint connector (CAN3) and the column switch connector.