[Previous][Next]
Inspection Procedure 19: The windshield washer tank fluid level sensor signal is not received.
 
 
cautionBefore replacing the ECU, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
TECHNICAL DESCRIPTION (COMMENT)
If there is an error to the windshield washer tank fluid level sensor input signal, the windshield washer tank fluid level sensor signal is no longer output to the communication line.
 
 
TROUBLESHOOTING HINTS
  • The windshield washer tank fluid level sensor may be defective
  • The ETACS-ECU may be defective
  • The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
 
 
DIAGNOSIS
Required Special Tools:
  • MB991223: Harness Set
  • MB992006: Extra Fine Probe
STEP 1. Check the windshield washer tank fluid level sensor.
Refer to GROUP 51 - Windshield washer inspection .
Is the check result normal?
Go to Step 2.
Replace the windshield washer tank assembly.
 
STEP 2. Resistance measurement at windshield washer tank fluid level sensor connector (ground terminal).
(1) Disconnect the connector, and measure at the wiring harness side.
(2) Measure the resistance between the windshield washer tank fluid level sensor connector (ground terminal) and ground.
OK: The resistance should be 2 ohms or less
Is the check result normal?
Go to Step 4.
Go to Step 3.
 
STEP 3. Check of open circuit in ground line between windshield washer tank fluid level sensor connector and ground.
Is the check result normal?
Intermittent malfunction is suspected (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).
Repair the connector(s) or wiring harness.
 
STEP 4. Check of short to power supply, short to ground, and open circuit in WFSW line between windshield washer tank fluid level sensor connector and ETACS-ECU connector.
Is the check result normal?
Go to Step 5.
Repair the connector(s) or wiring harness.
 
STEP 5. Using scan tool (M.U.T.-IIISE), check data list.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn off the power supply mode of the electric motor switch before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect Scan Tool (M.U.T.-IIISE) ."
(2) Check the ETACS-ECU data list.
  • Drain the washer fluid.
 
Item No.Item nameNormal condition
280Washer fluid/Trailer turn SWON
OK: Normal condition is displayed.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ).
Replace the ETACS-ECU.