STEP 1. Check the cruise control switch.
STEP 2. Resistance measurement at cruise control switch connector (ground terminal).
(1) Disconnect the connector, and measure at the wiring harness side.
(2) Measure the resistance between the cruise control switch connector (ground terminal) and ground.OK: The resistance should be 2 ohms or less
Is the check result normal?
Go to Step 4. Go to Step 3.
STEP 3. Check of open circuit in ground line between cruise control switch connector and ground.
STEP 4. Check of short to ground, and open circuit in DST+ line between cruise control switch connector and ETACS-ECU connector.
STEP 5. Using scan tool (M.U.T.-IIISE), check data list.
(1) caution | To prevent damage to scan tool (M.U.T.-IIISE), always turn off the power supply mode of the electric motor switch before connecting or disconnecting scan tool (M.U.T.-IIISE). |
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect Scan Tool (M.U.T.-IIISE)
."
(2) Check the ETACS-ECU data list.- When the cruise control switch (ACC distance switch) is pressed.
| Item No. | Item name | Normal condition | 406 | ACC distance switch | ON |
|
- When the cruise control switch (ACC distance switch) is not pressed.
| Item No. | Item name | Normal condition | 406 | ACC distance switch | OFF |
|
OK: Normal condition is displayed.
Is the check result normal?
The trouble can be an intermittent malfunction (Refer to GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunction ). Replace the ETACS-ECU.