[Previous][Next]
DTC B254F: IG status fault
 
 
 
 
DTC SET CONDITION
When the camera-ECU does not receive any electric motor switch status signals from the ETACS-ECU for 5 seconds, DTC No. B254F will be set.
 
 
TROUBLESHOOTING HINTS
  • The ETACS-ECU may be defective
  • The camera-ECU may be defective
  • The CAN bus may be defective
 
 
DIAGNOSIS
1. Using scan tool (M.U.T.-IIISE), diagnose the CAN bus line.
2. Using scan tool (M.U.T.-IIISE), recheck the DTC No. U0141.
3. Recheck the DTC (Check again if the DTC is set in the camera-ECU).