[Previous][Next]
DTC B2464: Meter information SW sticking
cautionBefore replacing the combination meter, ensure that the power supply circuit, the ground circuit and the communication circuit are normal.
 
 
 
 
DTC SET CONDITION
If the combination meter detects the meter information switch pressed state for 60 seconds or more continuously with the electric motor switch at the ON position and the DTC No. U1190 is not set, DTC No. B2464 is set.
 
 
TROUBLESHOOTING HINTS
  • The meter information switch may be defective
  • The combination meter may be defective
  • The wiring harness or connectors may have loose, corroded, or damaged terminals, or terminals pushed back in the connector
 
 
DIAGNOSIS
1. Meter information switch check. Refer to .
2. Check whether the DTC is set again.