[Previous][Next]
DISASSEMBLY AND REASSEMBLY
caution
  • Always replace the front seat cushion assembly together with the occupant classification-ECU.<Passenger’s side>
  • When replacing the front seat cushion assembly, be careful not to apply static electricity to it. <Passenger’s side>
  • The front seat cushion assembly must not be damped with any liquid or steam. <Passenger’s side>
 
 
<DRIVER’S SEAT (POWER SEAT)>
Disassembly steps
1.Seat belt inner
2.Hinge cover
3.Reclining adjuster lever knob
4.Slide adjuster lever knob
5.Side shield cover
6.Front seat lumbar support switch
7.Front power seat switch
8.Front power seat switch garnish
<<A>>9.Headrestraint guide
10.Front seat lumbar support harness
11.Seatback assembly
12.Hog ring
13. Seatback cover
14.Seatback pad
15.Seatback frame cover
<<B>>>>A<<16.Seatback frame assembly
17.Front seat lumbar support assembly
18.Seat cushion assembly
19.Hog ring
20.Seat cushion cover
21.Seat cushion pad
22.Slide adjuster side cover
23.Front power seat motor cover
24.Slide adjuster side cover
25.Side shield cover inner
26.Reclining adjuster cover
27.Front seat hook
28.Front seat hook
29.Power seat wiring harness
30.Seat cushion frame assembly
<PASSENGER’S SEAT (POWER SEAT)>
Disassembly steps
1.Seat belt inner
2.Hinge cover
3.Reclining adjuster lever knob
4.Slide adjuster lever knob
5.Side shield cover
6.Front power seat switch
7.Front power seat switch garnish
<<A>>8.Headrestraint guide
9.Seatback assembly
10.Hog ring
11.Seatback cover
12.Seatback pad
13. Seatback frame cover
<<B>>>>A<<14.Seatback frame assembly
15.Seat control unit wiring harness
<<C>>16.Seat cushion assembly
17.Slide adjuster side cover
18.Front power seat motor cover
19.Slide adjuster side cover
20.Side shield cover inner
21.Reclining adjuster cover
22.Front seat hook
23.Front seat hook
24.Power seat wiring harness
25.Seat cushion frame assembly
 
 
DISASSEMBLY SERVICE POINTS
 
 
<<A>> HEADRESTRAINT GUIDE REMOVAL
Remove the headrest guides while pushing the on both sides inward.
 

 
 
<<B>> SEAT BACK FRAME ASSEMBLY REMOVAL
For the vehicles with side-airbag, do not remove the side-airbag module from the frame.

 
 
<<C>> SEAT CUSHION ASSEMBLY REMOVAL
Always replace the seat cushion cover together with the seat cushion pad, the occupant classification sensor and the occupant classification-ECU, on which threshold values have been stored at the exchange part delivery.
 
 
 
REASSEMBLY SERVICE POINT
 
 
>>A<< SEATBACK FRAME ASSEMBLY INSTALLATION
To route the side airbag module wiring harness under the seat cushion, guide it through the fastener on the rear end of the seat cushion cover.
When the side airbag module is fitted in the seatback frame assembly, wrap reinforcement fabric of the seatback cover around the side airbag module and hook the assembly to the seatback frame assembly as shown, and then tighten the tapping screw securely.