[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Post-installation Operation
  • Door Inside Handle Knob Play Check (Refer to GROUP 42A, Door Inside Handle Check ).
  • Learning Procedures of Power Window Fully Closed Position (Refer to GROUP 42A, ON-Vehicle service ) <Driver’s door>
Front door trim removal steps
•Tweeter connector
1.Front door sash trim
<<A>>2.Inside handle cover cap
<<B>>3.Door trim cap
<<C>>>>A<<4.Front door trim
5.Power window switch assembly
6.Power window switch panel
•Power window switch connector
7.Power window switch
8.Remote-controlled mirror switch
9.Inside handle cover
10.Door beltline weatherstrip inner
11.Front door pull handle bracket
 
 
Rear door trim removal steps
<<A>>1.Inside handle cover cap
<<B>>2.Door trim cap
<<C>>>>A<<3.Rear door trim
4.Power window switch assembly
5.Power window switch panel
6.Power window switch
7.Inside handle cover
8.Door beltline weatherstrip inner
9.Rear door pull handle bracket
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> INSIDE HANDLE COVER CAP REMOVAL
Insert a flat-tipped screwdriver as shown in the figure to remove the inside handle cover cap.
 

 
 
<<B>> DOOR TRIM CAP
Insert a flat-tipped screwdriver as shown in the figure to remove the door trim cap.
 

 
 
<<C>> FRONT/REAR DOOR TRIM REMOVAL
Using a flat-tipped screwdriver as shown in the figure, remove the inside lock cable and the inside handle cable, then remove the door trim.
 

 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< FRONT DOOR/REAR DOOR TRIM INSTALLATION
After the power window switch is installed or replaced, perform learning of the power window fully-closed position (Refer to GROUP 42A - Door Glass and Regulator ).