STEP 2. Check of short to power supply circuit, short to ground circuit in W.AS line between the windshield wiper motor connector and ETACS-ECU connector.
STEP 3. Using scan tool (M.U.T.-IIISE), check whether the DTC is set again.
Check again if DTC No.B1E2D is set in the ETACS-ECU.(1) caution | To prevent damage to scan tool (M.U.T.-IIISE), always turn off the power supply mode of the electric motor switch before connecting or disconnecting scan tool (M.U.T.-IIISE). |
Connect scan tool (M.U.T.-IIISE). Refer to GROUP 54A - Diagnostic Function, "How to connect the Scan Tool (M.U.T.-IIISE)
."
(2) Erase the DTC.
(3) Turn the electric motor switch from the "OFF" position to the "ON" position.
(4) Turn the wiper switch to the LO or HI position and hold it for at least three seconds.
(5) Check if DTC is set.
Is the DTC set?
Replace the ETACS-ECU. Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunction ).