1. | caution | - Before performing the adaptation, check if the lighting control sensor (rain sensor)-related diagnostic trouble code is set in the lighting control sensor (rain sensor).
- Turn the wiper switch to the OFF position.
|
2. Clean the windshield in fine weather.
3. Wipe the surface of the windshield thoroughly, and check that the surface is dry.
4. Turn the electric motor switch to the "ON" position.
5. Turn the electric motor switch to the "OFF" position.
6. | caution | To prevent damage to scan tool (M.U.T.-IIISE), always turn the electric motor switch to the "OFF" position before connecting or disconnecting scan tool (M.U.T.-IIISE). |
Connect the scan tool (M.U.T.-IIISE) to the data link connector. Refer to GROUP 54A, Diagnostic Function - How to connect the Scan Tool (M.U.T.-IIISE)
.
7. Turn the electric motor switch from "OFF" position to "ON" position.
8. Wipe the windshield surface of the lighting control sensor section thoroughly, and check that the surface is dry.
9. Select "LIN" on the "System Select" screen, and press the "OK" button.
10. Select "Rain light sensor" on the "System Select" screen, and press the "OK" button.
11. Select "Special Function" on the "Rain light sensor" screen.
12. Select "Rain Sensor Adaptation" on the "Special Function" screen.
13. Press the "OK" button, and execute the "Rain Sensor Adaptation."
14. Press the "OK" button after the execution screen is displayed.
15. Press the "OK" button after "Completed" is displayed.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)