REMOVAL AND INSTALLATION
Post-installation operation
Door adjustment (Refer to
.)
Front door assembly removal steps
•
Cowl side trim (Refer to GROUP 52A - Interior Trim
.)
1.
Wiring harness connector connection
2.
Door check connecting bolt
3.
Front door assembly
Front door hinge removal steps
•
Side air dams (Refer to GROUP 51 - Side Air Dams
.)
3.
Front door assembly
4.
Fender protector rear
5
Front door upper hinge
6.
Front door lower hinge
Striker removal steps
>>A<<
7.
Striker
8.
Shim
Damper removal
9.
Damper
Door switch removal
10.
Door switch
Rear door assembly removal steps
1.
Wiring harness connector connection
2.
Door check connecting bolt
3.
Rear door assembly
Rear door hinge removal steps
•
Center pillar trim (Refer to GROUP 52A - Interior Trim
.)
3.
Rear door assembly
4.
Rear door upper hinge
5.
Rear door lower hinge
Striker removal steps
>>A<<
6.
Striker
7.
Shim
Damper removal
8.
Damper
Door switch removal
9.
Door switch
INSTALLATION SERVICE POINT
>>A<< STRIKER INSTALLATION
Align the center of the striker and latch within ±1.5 mm (0.06 inch), and install.
.)![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
)
)
)