[Previous][Next]
TORQUE SENSOR CALIBRATION
cautionAfter the next operation has been completed, carry out the following two operations:
  • Alignment adjustment <Front>
  • Steering wheel and steering wheel sensor (column switch assembly) replacement, removal, installation
  • EPS-ECU replacement
  • Steering column shaft assembly replacement
  1. Reset the calibrated value of the torque sensor neutral position stored in EPS-ECU.
  2. Update the steering wheel neutral position stored in the EPS-ECU.
caution
  • Before performing the calibration, check if the steering wheel sensor-related DTC is set in ASC-ECU.
  • When the DTC other than C1518 and C1519 are set, carry out inspection according to each troubleshooting procedure.
1.
cautionDo not apply torque to the steering wheel.
Park the vehicle on a level surface with tires and steering wheel positioned in a straight ahead direction.
2.
cautionBefore connecting or disconnecting scan tool (M.U.T.-IIISE), always turn off the power supply mode.
Before setting scan tool (M.U.T.-IIISE), turn off the power supply mode.
3. Power supply mode: ON
4. Select "ECPS/4WS."
5. Select "Special function."
6. Select "Sensor calibration."
7. Select and run "Torque sensor calibration."
8. Check whether the EPS-ECU-related DTC is set.
9. Confirm that DTC No. C1518 and C1519 are not set in the EPS-ECU. If those DTC are set, start torque sensor calibration again from the beginning.
10. Before removing scan tool (M.U.T.-IIISE) from the vehicle, turn off the power supply mode.