[Previous][Next]
DTC C2299 Implausible coding data
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines.
  • Whenever the ECU is replaced, ensure that the communication circuit is normal.
 
 
OPERATION
FCM/LDW/AHB-ECU receives the vehicle information stored in ETACS-ECU via CAN bus lines.
 
 
DTC SET CONDITION
This DTC is set when the abnormality below is detected:
  • The vehicle information received from ETACS-ECU is not correct.
 
 
TROUBLESHOOTING HINTS
  • Malfunction of the CAN bus line
  • Implausible ETACS-ECU coding data
  • Malfunction of the ETACS-ECU
  • Malfunction of the FCM/LDW/AHB-ECU
 
 
DIAGNOSIS
STEP 1. Scan tool (M.U.T.-IIISE) CAN bus diagnostics.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn off the power supply mode of the electric motor switch before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Turn on the power supply mode of the electric motor switch.
(3) Diagnose the CAN bus line.
(4) Turn off the power supply mode of the electric motor switch.
Is the check result normal?
Go to Step 2
Repair the CAN bus lines (Refer to GROUP 54C - Troubleshooting ).
 
STEP 2. Scan tool (M.U.T.-IIISE) other system DTC.
Check the ETACS DTC.
Is the DTC set?
: Perform chassis number writing and coding. Refer to the "M.U.T.-III operation manual" and perform coding.
: Perform the relevant troubleshooting (Refer to GROUP 54A - DTC chart ).
Go to Step 3
 
STEP 3. Check whether the DTC is set again.
Check again if the DTC is set in the FCM/LDW/AHB-ECU.
(1) Erase the DTC.
(2) Turn off the power supply mode of the electric motor switch.
(3) Turn on the power supply mode of the electric motor switch.
(4) Check if DTC is set.
Is the DTC set?
Replace the FCM/LDW/AHB-ECU (Refer to ).
This diagnosis is complete.