[Previous][Next]
Inspection Procedure 5: Brake warning light does not illuminate when the electric motor switch is turned ON.
 
 
caution
  • If there is any problem in the CAN bus lines, an incorrect DTC may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C - CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
 
 
OPERATION
  • ASC-ECU sends the illumination request signal of the break warning light to the combination meter through ETACS-ECU via the CAN communication.
  • ASC-ECU illuminates brake warning light via ETACS-ECU for approximately 3 seconds for bulb check with the electric motor switch turned to the ON position.
 
 
 
COMMENTS ON TROUBLE SYMPTOM
This may be caused by faults in the CAN bus line, ETACS-ECU, combination meter or ASC-ECU.
 
 
 
TROUBLESHOOTING HINTS
  • Damaged wiring harness and connectors
  • Malfunction of ETACS-ECU
  • Malfunction of the combination meter
  • ASC-ECU malfunction
 
 
 
 
DIAGNOSIS
STEP 1. Scan tool (M.U.T.-IIISE) CAN bus diagnostics.
(1)
cautionTo prevent damage to scan tool (M.U.T.-IIISE), always turn off the power supply mode of the electric motor switch before connecting or disconnecting scan tool (M.U.T.-IIISE).
Connect scan tool (M.U.T.-IIISE). Refer to "How to connect the Scan Tool (M.U.T.-IIISE) ."
(2) Turn on the power supply mode of the electric motor switch.
(3) Diagnose the CAN bus line.
(4) Turn off the power supply mode of the electric motor switch.
Is the check result normal?
Go to Step 2.
Repair the CAN bus lines. (Refer to GROUP 54C - CAN Bus Diagnostics Table .)
 
STEP 2. Scan tool (M.U.T.-IIISE) DTC.
Use scan tool (M.U.T.-IIISE) to check the DTC for the ASC system.
Is the DTC set?
Carry out the diagnosis for the DTC (Refer to ).
Go to Step 3.
 
STEP 3. Scan tool (M.U.T.-IIISE) Special Function for other system.
Perform the following special function by the combination meter system, and check if the ABS warning light illuminates (Refer to GROUP 54A - Combination Meter ).
  • Item No. 6: Indicator (AUTO)
Is the check result normal?
Go to Step 4.
Replace the combination meter.
 
STEP 4. Scan tool (M.U.T.-IIISE) other system DTC.
Using scan tool (M.U.T.-IIISE), check that DTC No.U0141 is not set in the combination meter system.
Is the DTC set?
Diagnose the combination meter (Refer to GROUP 54A - Combination Meter/DTC ).
Go to Step 5.
 
STEP 5. Scan tool (M.U.T.-IIISE) other system DTC.
Using scan tool (M.U.T.-IIISE), check that DTC No.U0121 is not set in the ETACS system.
Is the DTC set?
Perform troubleshooting on ETACS-ECU (Refer to GROUP 54A - ETACS/DTC ).
Go to Step 6.
 
STEP 6. Retest the system.
Does the brake warning light turn ON and OFF
Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/How to Cope with Intermittent Malfunctions ).
Replace the hydraulic unit (ASC-ECU) (Refer to ).