[Previous][Next]
REMOVAL AND INSTALLATION
 
 
caution
  • Handle the evaporative emission canister as follows.
    1. Do not allow grease or other oil to adhere to the O-ring when mounting the mating parts. When using an auxiliary insertion agent, use isopropyl alcohol.
    2. Do not directly touch the connector terminal of the evaporative leak check module (ELCM) section because there is a possibility that the IC chip may be damaged by static electricity.
    3. Do not use the evaporative emission canister when it has been dropped.
    4. Do not allow water, gasoline etc. to adhere to the connector section.
    5. Do not transport it by holding the ELCM section.
  • Handle the fuel tank solenoid valve as follows.
    1. Do not use the fuel tank solenoid valve when it has been dropped.
    2. Do not transport it by holding the relief valve section and the hose section.
    3. Handle it so that the pipe seal section of each nipple will not be scratched.
    4. Because connecting the tube or harness connector may cause a grommet break, perform it after fixing the fuel tank solenoid valve body.
Removal steps
1.Bypass valve connector connection
2.Evaporative leak check module connector connection
3.Fuel pipe connection
4.Ventilation hose B
5.Ventilation pipe
6.Ventilation hose A
7.Ventilation connector
8.Air filter
9.Fuel vapor tube B
10.Evaporative emission canister protector
11.Evaporative emission canister
12.Evaporative emission canister bracket
Fuel tank (Refer to GROUP 13B, Fuel Tank .)
13.Fuel filler leveling tube connection
14.Fuel vapor tube A
15.Fuel vapor pipe
16.Fuel tank solenoid valve connector
17.Fuel tank solenoid valve bracket
18.Fuel tank solenoid valve