[Previous][Next]
TIMING CHAIN LEARNED VALUE RESET
 
 
Required Special Tools:
  • MB992744: Vehicle Communication Interface-Lite (V.C.I.-Lite)
  • MB992745: V.C.I.-Lite Main Harness A
  • MB992747: V.C.I.-Lite USB Cable Short
  • MB992748: V.C.I.-Lite USB Cable Long
  • MB991958: Scan Tool (M.U.T.-III Sub Assembly)
    • MB991824: Vehicles Communication Interface (V.C.I.)
    • MB991827: M.U.T.-III USB Cable
    • MB991910: M.U.T.-III Main Harness A (Vehicles with CAN communication system)
cautionTo prevent damage to the scan tool (M.U.T.-IIISE), always turn off the power supply mode of the electric motor switch before connecting or disconnecting the scan tool (M.U.T.-IIISE).
1. After the power supply mode of the electric motor switch is OFF, connect scan tool (M.U.T-IIISE) to the data link connector.
2. Operate the electric motor switch without depressing the brake pedal and turn ON the power supply mode of electric motor switch.
3. Select "MFI" from System select Screen of the scan tool (M.U.T.-IIISE).
4. Select "Special Function" from MFI Screen.
5. Select "Timing chain maintenance" from Special Function Screen.
6. Select "Learned value reset" from Timing chain maintenance Screen.
7. Press "ON" to reset the learning value.