DTC P0D67: BATT. Charger Control Circuit Abnormal

MONITOR EXECUTION

Continuous

MONITOR EXECUTION CONDITIONS (Other monitor and Sensor)

Not applicable

Not applicable

DTC SET CONDITIONS

OBC power supply voltage is 10 volts to 16 volts.

• Change of the 3.3 V power module voltage is less than 3 volts or more than 3.6 volts for 1 second.
  
• Change of the 6 V power module voltage is less than 5.3 volts or more than 6.8 volts for 1 second.
  
• Change of the 12 V power module voltage is less than 9.4 volts or more than 14.9 volts for 1 second.
  

OBD-II DRIVE CYCLE PATTERN

Refer to OBD-II Drive Cycle - Pattern 1 .

FAIL-SAFE AND BACKUP FUNCTION

• The charge is stopped.
  

PROBABLE CAUSE

• The on board charger/DC-DC converter is failed.
  

(1)Carry out a test drive with the drive cycle pattern. Refer to OBD-II Drive Cycle - Pattern 1 .

	Replace the on board charger/DC-DC converter (Refer to ). Then go to Step 2.

	Intermittent malfunction (Refer to GROUP 00 - How to Use Troubleshooting/Inspection Service Points - How to Cope with Intermittent Malfunctions ).

(1)Carry out a test drive with the drive cycle pattern. Refer to OBD-II Drive Cycle - Pattern 1 .

	Retry the troubleshooting.

	The inspection is complete.